Triggers can be used to automate tasks when an Input either begins a transition (OnTransitionIn), begins a transition out (OnTransitionOut) or when a video completes playback (OnCompletion)

OnOverlayIn and OnOverlayOut can also be used when an Input is used as an Overlay

An unlimited number of tasks can be added, with each task running in the order it appears in the list.


In the example above the Title 1 input is turned on as an overlay 1 second after the current input begins a transition. After 5 seconds the overlay is turned off again.


Trigger


  • OnTransitionIn
  • OnTransitionOut
  • OnOverlayIn
  • OnOverlayOut
  • OnCompletion (applies to video, list, photos and powerpoint inputs when they reach the end assuming Loop is not enabled).
  • OnCountdownCompleted (applies to the title input, when a configured countdown clock reaches 0)


Function


Select a task or transition effect (such as Fade, Cut etc)

Note that in order to prevent loops, transition effects have no effect for OnTransitionIn or OnTransitionOut.


Input


Select the Input the Function applies to (if applicable)


Duration


Select the duration of the transition effect (if applicable)


Delay


This trigger will wait for the selected amount of time (in milliseconds) before completing the selected Function and moving on to the next item in the list.


Triggers that use the same triggering name (such as OnTransitionIn) will run one after the other in the order that they are listed. In the example below, the OverlayInput1 function will be triggered 5 seconds after the ‘Input 1: Sample Video’ has transitioned to the main screen, and then an additional 2 seconds after this, the OverlayInput2 function will be triggered.



Important Note: Delay is limited to 30 seconds maximum (30000 ms). Any delay higher than this will be limited to 30 seconds by vMix, to prevent triggers occurring later in a production unexpectedly.
Therefore, Triggers should not be used for long running operations, instead look at the PlayList or Scripting features.


Triggers and MultiView Overlays


Triggers will only be activated on the primary input. For example if Input A is setup with Input B and C as MultiView Overlays, only the Input A trigger will be used.
The exception to this is OnCountdownCompleted which will trigger regardless.